Connects2 Vision Camera Kits UK

How to choose a Connects2 Vision camera kit in 2026

Adding a reversing or front camera to a factory screen is the cleanest, most resale-friendly camera upgrade you can fit to a modern car. Connects2 Vision is the UK installer favourite because the kits are vehicle-specific, plug-and-play and retain the original OEM head unit, with no risk of voiding the manufacturer warranty on screen software. This guide explains how to choose the right kit for your car and what to expect from the install.

Will it work with my factory screen?

Connects2 Vision interfaces are designed against the original screen model. Each kit is built for a specific year, trim and software version, so the menu integration, reverse trigger and dynamic parking lines match the factory behaviour. The interface sits behind the dash and intercepts the stock video bus, no soldering required. If you are unsure which interface fits your car, phone us with the registration and we will confirm the right part before you order.

Camera type: aftermarket or OEM-style?

We supply two camera styles. OEM-style cameras replace the factory tailgate handle, manufacturer badge or number-plate light for a fully invisible install. Aftermarket cameras mount above the plate or on the boot lid and are quicker to fit. Both deliver sharp daylight image quality and useful low-light performance, with IP67 weather sealing as standard. Choose OEM-style if resale value matters, aftermarket if speed of install is the priority.

• OEM badge cameras. Sit behind the manufacturer badge for a stealth look.
• Number-plate cameras. Easy fit, neutral mount, no body work.
• Handle cameras. Replace the tailgate handle in supported VW Group cars.
• Wide-angle cameras. Up to 170 degrees for tight bay parking.

Video signal and parking lines

Connects2 Vision interfaces support CVBS analogue and RGB digital video depending on the host vehicle. Many kits provide active parking lines that move with the steering angle for confident tight-spot parking. Look for kits with at least 480p video, balanced auto-exposure, a clear guideline overlay and a clean wiring diagram. Where the car has a 360 surround view system, we can supply an alternative interface that adds an aftermarket reverse feed without disturbing the factory cameras.

Brand quality at a glance

• Connects2 Vision. UK-designed integration interfaces, full installer documentation.
• Connects2 main range. Fascia kits, harness adapters and steering-wheel control modules.
• Sony, Pioneer, Kenwood. Aftermarket head units that work alongside Vision integration.
• Beat-Sonic. Premium OEM-style camera housings for select Japanese vehicles.

Compatibility and fitting

Most Vision installs need a small set of supporting parts.

• Vehicle-specific interface. Matches your factory screen and CAN system.
• Camera harness. Runs from the boot to the interface in the dash.
• ISO harness adapter. Required on certain hybrid and electric models for ignition feed.
• Trim removal tools. Plastic prying tools to lift dash panels without damage.

Installation guidance

A confident DIYer with a trim tool kit can fit a Vision camera in a long afternoon. Routing the harness through the tailgate rubber gaiter is the trickiest part, since the wires have to bend without snagging when the boot opens. The interface module sits behind the dash and connects to the head unit ribbon, which sometimes needs the screen module removed for access. We supply a printed fitting guide with every kit, clear photo references and a phone-in helpline if you get stuck. If you prefer to have the job done for you, we can book a workshop fitment slot in Wolverhampton, normally same-week.

Why buy Connects2 Vision from Bass Junkies

Bass Junkies has been supplying integration kit since 1995. We hold genuine UK stock, ship same-day on weekdays and pre-check each Vision kit against the registration on request. For fitment advice or to confirm interface compatibility, call our Wolverhampton workshop on 01902 863 005.